System Features ....................... 4
System Components ..................... 4
Required Tools ........................ 4
Technical Assistance................. 4-5
Before You Begin ...................... 5
Precautions...........................
6
Using your Test Probe.................. 6
Making Wiring Connections ............ 6-8
Locating & Making Connections ....... 8-12
Connecting the Wiring Harness ......... 13
Neutral Safety Switch................. 14
Operator Programming Instructions...... 15
How to use Your Remote Transmitter..... 16
Vehicle Anti-theft System Chart..... 17-20
FCC ID Notice ........................ 20
Important Functions................ 21-22
Warranty Validation .................. 21
Your Warranty ........................ 23
REMOTE STARTER • MODEL RS82I/RS85I/RS79
CONTENTS
22
3
Protected by one or more
of the following patents:
Patent #5,459,477 Patent #5,612,670
Patent #5,886,622 Patent #5,677,664
Patent #5,942,988 Patent #6,101,428
Patent #6,452,772
Other patents pending.
ATTENTION:
We urge you to immediately place this card in your wallet.
PLEASE FILL OUT THIS FORM
AND MAIL IT IN TO REGISTER YOUR WARRANTY
Your Name ________________________________________
Address ________________________________________
________________________________________
Email Address _________________________________
Dealer Name ____________________________________
Address ________________________________________
________________________________________
Date of Purchase ___/___/___ Model # __________
Make/Model of Car ______________________________
Year of Car _____ V.I.N. # ____________________
Final Quality Check By _________________________
WARRANTY VALIDATION
Mail to: JBS Technologies
225 Technology Way • Steubenville, Ohio 43952
PROGRAMMING FUNCTIONS
FOR YOUR WALLET OR GLOVE BOX
Adding Additional Remotes
The hood must be open or the hood pin wire must be grounded. Then,
press and hold Button #1 on the working transmitter for ten (10)
seconds or until the ignition relay clicks or the check engine
light flashes once, release Button #1. Press and release any button
on the new remote control. The ignition relay will click or the
check engine light will flash three (3) times. Close the hood or
remove the hood pin wire from ground and try both remotes.
Tach/Tachless Option The brake must be depressed.
Press and hold Button #1 for 5 seconds or until the ignition relay
clicks or the check engine light flashes once. Release. Press and
release Button #1, the ignition relay clicks or the check engine
light flashes once. The unit is now programmed for Tachless Mode.
Press and release Button #2, the ignition relay clicks or the check
engine light flashes twice. The unit is now programmed for Tach
Mode. NOTE: The factory setting is Tachless Mode.
