The blade should be set so it cuts into the plastic blade stop
d
when the handle is pressed down.
To set the blade depth, rotate the two large nuts
e
on the underside of the base with a 1.5” (38mm) wrench.
Ensure that both are turned an equal amount.
Adjust in 1/4 turn increments and check to see how deep the blade is set.
To open the blade to cut 1” material, loosen the Back Stop Knob
f
and rotate the Back Stop
g
up.
DO NOT CUT HARDWOOD
WITH THIS SHEAR!
1. To unlock, gently press handle down,
slide Bullet Cam-Lock
a
in and down.
2. Place material
b
on table,
and slide under blade to desired cut position.
3. Push handle
c
down until material is completely cut.
QUICK START GUIDE
Your Magnum Shear cuts a wide variety of products.
Please refer to cut guide for recommended products and thicknesses.
Please note: Approved materials may vary in density and hardness.
If extreme pressure is required to cut a product, it may result in damage to your
machine. Please contact Bullet Tools before proceeding.
Warranty is void if an unapproved product damages the machine.
a
d
e
f
g
ADJUSTMENTS:
IN USE:
b
c
MS60-1613 Siding Shear
Install Mounting Brackets and Attach to Cut Station or Stand
Using a T30 bit (included) and socket or screw driver, unscrew four lower rail attachment bolts 1/4” (6mm).
Slip mounting brackets
x
up over rail attachment bolts and tighten securely.
Fasten to chop-saw stand or cut station using appropriate hardware
such as 5/16” diameter bolts or lag-screws and corresponding washers (not included).
When using a bench-type cut station, it is convenient to fasten some dimensional lumber in place as
‘spacers’ before attaching your shear.
x
●
Siding, Fiber cement lap
●
Siding, Pressboard lap
●
Siding, Vinyl
●
Trim, OSB
●
Trim, Fiber cement
●
Trim, Vinyl
SIDING CUT GUIDE
●
Shingles, Tar or Wood
Max Thickness = 1” or 25mm
