C Prox Ltd (inc Quantek)
59 Sheffield Road, Dronfield, S18 2GF
+44(0)1246 417113 sales@cproxltd.com www.quantek.co.uk
GO-KEY User Manual
Description
Wireless 868MHz 4 channel keypad, for use with JCM control panels with built in receiver and
standalone receivers.
- 4 different codes can be programmed to enable 4 independent channels.
- The code will be from 1 to a maximum of 8 figures.
- The codes are not deleted from the memory, even when the battery is disconnected.
- The keypad remains in low consumption status to save battery.
Technical specification
Operating frequency
868.35MHz rolling code
Power supply
2 x 1.5V AAA batteries
Operating/standby consumption
12mA / 0.002mA
Radiated power
<25mW
Operating temperature
-20⁰C to +55⁰C
Tightness
IP43
Dimensions
75x75x65mm
Installation
Remove the keypad from the back box and secure the back box to the wall within 30 metres of the
control panel or receiver. Insert the batteries, replace the keypad and attach the keypad and face
plate to the back box using the security screws provided.
Programming
Master code:
Press the
✳
✳
✳
✳
key for 3 seconds until the led issues a slow red flashing light. Enter the master code
(factory issue is 12345678) and press OK. The led will issue a faster red flashing light. Press the
✳
✳
✳
✳
button. Enter the new master code and press the
✳
✳
✳
✳
key again. The led will issue a faster green
flashing light. Enter the master code again and press the
✳
✳
✳
✳
key. The led will issue a permanent
green light for 2 seconds to indicate that the new master code has been correctly programmed
before switching off.
