CTADM-806 Installation Manual
This Package Contains:
One CTADM-806 Rack Mount
Agile Audio/Video Demodulator
One Installation Manual
Product Diagram and Description:
Hardware Connections:
1. The CTADM-806 is designed for installation in a 19” rack.
2. Connect a 75ohm coaxial cable with F-Connectors from the CTADM-806’s
RF Input
port
to the Off-Air antenna or other source.
3. Connect a 75ohm coaxial cable with F-Connectors from the CTADM-806’s
Audio Output
port
to the modulator’s Audio Input.
4. Connect a 75ohm coaxial cable with F-Connectors from the CTADM-806’s
Video Input
port to the modulator’s Video Input.
5. Connect the CTADM-806 to an appropriate power source capable of powering this
device. Be certain that power source is capable of handling the load if the CTADM-806
and other equipment are being powered by it.
Channel Selection:
1. The CTADM-806 can demodulate audio and video signals from any CATV channel from 2
to 125 or any Off-Air channel from 2 to 69 in the 54 MHz to 806 MHz frequency range. If
demodulating a signal from an Off-Air channel press the
ANT/CATV Button
so
no dot
appears in the LED Channel Display
. If a CATV channel is to be demodulated then
press the ANT/CATV Button so a dot appears in the LED Channel Display.
2. Set
HRC/STD/IRC Switch
to
STD
unless your signal source is HRC or IRC.
1
