* ATTENTION:
Read complete instructions thoroughly before drilling and installing
any parts of the CAL "Double-Bolt" locking system
The Latch for this system is designed for use in standard door frames (Jamb).
"Checking the Latch"
The latch is the most important component to the CAL "Double-Bolt" system. Before you install any part of the system to your
door jamb or door, make sure the latch correctly fits your door jam depth. The latch must fit perfectly in the door jamb in
relationship to the height of the latch and the depth of the door jamb.
Check the depth of door jamb by inserting latch into the door jamb. The flat drilled section of the latch should fit flat to the back of the
doorjamb. The leading edge of the latch must overlap the interior wall of the doorjamb frame. If the doorjamb is slightly deeper than
the height of the latch, place spacers on back of latch and re-check depth.
