XT-2150 User Manual
Last Modified on 12/23/2015 10:05 pm EST
Installation
Wiring Cable Identifier
Red cable – Power supply (12V)
Black cable – Ground
White cable – Ignition Sense
Connect the GPS Tracker
Connect the cables as described in section “Wiring Cable Identifier”. After the unit is
powered, make sure that the blue status LED is blinking at at the rate of once every 3
seconds. When first powered up, it will blink at the rate of once every second and within 1-2
minutes, it will blink at the rate of once every 3 seconds. This indicates that it has an
available connection with the cellular network. Final installation should be done only
after the blue led blinks at the rate of once every 3 seconds
