background image

FT-164 M-Series Rosette Fountain 

Assembly Instructions

rev 3/30/2020

Fountain Information:

 

• This fountain holds approximately 3/4 gallons of water.
• A fountain cover is not available for this fountain.
• No refill device or submersible lights are suggested for this fountain.

Pump Information:

 

WP450LV - 120 GPH Low Voltage Pump (16 ft. cord length)

Tools Required:

  

Bubble Level 
Screwdriver 
Scissors

Pump Kit Parts List

Image

Component

Quantity

PK120-LV Pump with Transformer

1

#7 Stopper

1

2" length of PermaGum Putty

1

Approx. 8" length of 1/2" black 

non-kink tubing

1

1" length of 5/8" clear tubing

1

1" length of 1/2" CPVC pipe

1

Adhesive Dots

4

Hose Clamps

1

Fountain Components

Image

Item Description

Component 

Item #

Quantity

M-Series 

Rosette 

Fountain - 

Water Feature

FT-164A

1

M-Series 

Rosette 

Fountain - Basin

FT-164B

1

Proudly 

MADE IN USA

Summary of Contents for Rosette M Series

Page 1: ...tage Pump 16 ft cord length Tools Required Bubble Level Screwdriver Scissors Pump Kit Parts List Image Component Quantity PK120 LV Pump with Transformer 1 7 Stopper 1 2 length of PermaGum Putty 1 Approx 8 length of 1 2 black non kink tubing 1 1 length of 5 8 clear tubing 1 1 length of 1 2 CPVC pipe 1 Adhesive Dots 4 Hose Clamps 1 Fountain Components Image Item Description Component Item Quantity M...

Page 2: ... components seem off rotate components or use wedges to level them Step 3 Create a Drip Loop To prevent water from dripping down the cord and damaging the electrical socket create a drip loop by allowing the pump power cord to fall below the wall outlet Step 4 Use a GFCI Outlet Use only a GFCI outlet when running a fountain Step 3 Assemble the pump kit 3a NOTE Do not plug the pump into the transfo...

Page 3: ...the stopper See image D Let the fountain dry completely then use 100 clear silicone to seal around the pump cord and perimeter of the stopper Silicone must set for 24 hours before adding water D Step 7 Holding the water feature FT 164A over the basin FT 164B insert the CPVC end of the tubing into the coupling protruding from the bottom Step 8 Center the water feature FT 164A into basin FT 164B Ste...

Page 4: ...is completely seated in the fountain You can also use 100 pure clear silicone to ensure a proper seal is achieved Step 4 Cracking Your fountain may be cracked from improper winter care see Winter Care in Maintenance Tips Maintenance Pump Care The fountain relies heavily on the quality of the pump A well maintained pump can last several years Step 1 Fully submerge Ensure the pump is fully submerged...

Reviews: