For parts, product & service information visit
www.campbellhausfeld.com
© 2015 Campbell Hausfeld
A Marmon/Berkshire Hathaway Company
IN744700AV 7/15
MODEL: CL152099
Description
Air powered die grinders are designed for grinding, polishing, deburring and
smoothing sharp edges. This tool may be used with carbide burrs. Different collets
are available which serve as adapters for virtually all standard grinding accessories.
In addition, this tool may also be used for gasket removal and weld grinding. Angled
heads allow access to tight or difficult to reach areas. Front exhaust models direct air
away from user’s face.
Unpacking
After unpacking the unit, inspect carefully for any damage that may have occurred
during transit. Make sure to tighten fittings, bolts, etc., before putting unit into service.
READ & FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
Safety Guidelines
This manual contains information that is very important to know and understand. This
information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To
help recognize this information, observe the following symbols.
Danger indicates an imminently hazardous situation which, if
not avoided, WILL result in death or serious injury.
Warning indicates a potentially hazardous situation which, if not
avoided, COULD result in death or serious injury.
Caution
indicates a potentially hazardous situation which, if not
avoided, MAY result in minor or moderate injury.
Notice indicates important information, that if not followed, may
cause damage to equipment.
NOTE:
Information that requires special attention.
General Safety Information
CALIFORNIA PROPOSITION 65
This product or its power cord may contain chemicals, including
lead, known to the State of California to cause cancer and birth
defects or other reproductive harm. Wash hands after handling.
Operating Instructions
Air Die Grinders
