9200_9200_VIB_UserGuide_02_09_2023
Page 1 of 3
9200 SERIES
BLOWERS
INSTALLATION AND MAINTENANCE INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
GENERAL SAFETY
Rotating parts, (pulleys, shafts and belts) on fans should not be exposed. Where
these components are not protected by ductwork, cabinets or covers, appropriate
guards should be employed to restrict exposure to rotating parts. Access doors
should not be opened with the fan operating to avoid foreign objects being drawn
into the system. On initial start-up, a careful inspection should be carried out to
ensure no foreign material is present which could become airborne in the system.
Read installation and operation instructions carefully before attempting to install,
operate or service Canarm/Delhi 9200 Series. Failure to comply with instructions
could result in personal injury and/or property damage.
Retain instructions for future reference.
BEFORE YOU BEGIN
Inspect unit for damage, report any shipping damage to carrier. Check all fasteners, re-tighten as required. Rotate the blower wheel by
hand to ensure free rotation. If rubbing occurs, loosen the set screw(s), re-position the wheel to the shaft center, re-tighten set screws.
INSTALLATION
9200 series blowers are suitable for suspension or base mounting.
BASE MOUNT
SUSPENDED MOUNT
RIGID
MOUNT
OR
OR
RUBBER
ISOLATOR
RIGID MOUNT
SPRING
ISOLATOR
* Flexible inlet and outlet collars are recommended to minimize vibration transmission.
9200 SERIES
BLOWERS
9200 SERIES
BLOWERS
BASE MOUNTING
For base mounting secure unit through 4 - 7/8" diameter holes located in the "hat section" channel in the bottom of the unit. Ensure
unit is level.
SUSPENSION MOUNTING
Drill 4 - 7/8" diameter holes through the top using the inside top "hat section" channel as a guide. Extend 1/2" diameter threaded
mounting rod through the cabinet and the bottom channel and secure to both top and bottom. Ensure unit is level.
Installation or Product problems? Do not return to store of purchase.
Contact Canarm Service at 1-800-265-1833 (CANADA) 1-800-267-4427 (U.S.A.)
1-800-567-2513 (EN FRANCAIS) Monday to Friday 8:00 - 5:00pm e.s.t.
Canarm Ltd. - Corporate Head Office
2157 Parkedale Avenue, PO Box 367 Brockville, Ontario Canada K6V 5V6
Tel: (613) 342-5424; Fax: (613) 342-8437
www.canarm.com
hvacsales@canarm.ca
