Canon Creative Park JAGUAR XKR, Assembly Instructions Manual

- 1 -

Assembly Instructions ; 

Seven

A4

sheets

No. of Parts 

;

49

*

Bulid the model by carefully reading the Assembly Instractions, in the parts sheet page order.

The Jaguar XKR brings the Jaguar Sports Car tradition that began with the XK 120, into the modern era.  The sleek 

curves of the Jaguar XKR are reminiscent of the Jaguar E-type, a timeless classic from the 1960s, and give the car 

an exemplary "British" air.  Features inside include new twin air intakes, and the Super Charged 4.2 liter V8 engine 

employs a variable inlet camshaft timing system that extracts a peak torque of 560Nm and a maximum power output 

of 420hp.  The Jaguar XKR accelerates from 0 to 100km/h in just 5.2 seconds.  The super charger means that high 

levels of power and torque are achieved at any engine speed.

This papercraft is about one eighteen the size of a real Jaguar XKR.

*This model was designed for Papercraft and may differ from the original in some respects.

JAGUAR XKR

View of compleate model

(Front view)

View of compleate model

(Side view)

View of compleate model

(Back view)

Mountain fold

Valley fold

Scissors line

Instructions

1

. Use scissors to cut out all the pieces carefully.

2

. To add curves, take the part in your hand and use a cylindrical rod to work a curve into it.

3

. Check the instructional diagrams for mountain folds and valley folds, and use something pointed to score along the fold lines.  It is 

important to make each fold clean.

4

. Before gluing, look at the instructional diagrams and photos and put the pieces together roughly to see how the finished product should 

look.  This will also give you an idea of where to add curves.

If the white edges of the parts you have cut stand out, color them with a marker pen or paint in the same color as the part before gluing.  

This will result in a cleaner finish.

5

. After placing the pieces together roughly, add glue to the glue tabs (marked      ) and assemble the model.

Pour some glue onto a piece of paper, and use a toothpick to spread a thin layer on the glue tabs.  This will ensure a clean finish.

Be sure to attach the parts in order as shown by the numbers in squares.  Take your time and glue each one carefully.

Glue tab

Notation Key

Tools

Scissors       Ruler      Glue      An instrument with a pointed tip (eg. a stencil pen or bodkin)

     A cylindrical rod (a knitting needle or pencil)       Tape     Tweezers     Toothpicks 

     Something to color the edges of the paper after cutting (a marker or some paint)

     A craft mat  etc

Glue, scissors and other tools may 
be dangerous to young children so 
be sure to keep them out of the 
reach of young children.
Be careful not to cut your fingers 
when using scissors. 

Cut in line

JAGUAR  XKR : Assembly Instructions