I N S T A L L A T I O N I N S T R U C T I O N
P R O D U C T D I M E N S I O N S
CANOPY RANGEHOOD
TELESTO MODEL NUMBER RHT9SS.
PLEASE READ THE ENTIRE INSTRUCTION BEFORE INSTALLING THE CANOPY
All Dimensions are in mm
O/I
II
III
Fan On / Off
Mid Speed
High Speed
Delay Switch
Light On / Off
BULB
I N S T A L L A T I O N O P T I O N A C C E S S O R I E S
Electrical Rating:
386W (1.6A)
Max. at 230-240V 50Hz
MANUFACTURED IN NEW ZEALAND BY:
ROBINHOOD LIMITED
P.O. BOX 51 201, PAKURANGA,AUCKLAND, N.Z.
TEL: +
64 9 272 5129 •
FAX: +
64 9 272 5148
ISO9001 Certified
RECOMMENDED UNIDUCT DUCTING
SYSTEMS FOR RANGEHOODS
320mm
900mm
72mm
500mm
280mm
Ducted - 530 to 830mm
Recirc - 630 to 830mm
104775 issue D
ECN 06 072
CONTROL
PANEL
Delay switch - Fan will remain on at low, mid or high speed for 5 mins. before
switching off automatically.
LIGHT REPLACEMENT
a) Switch off the power to rangehood.
b) Use a small bladed screwdriver to prise off the light cover.
c) Use a cloth to remove the bulb. Do not touch the bulb with fingers.
d) Replace with a new bulb using a cloth. Do not touch the bulb with fingers.
“Snap” the cover back in place.
e) Halogen bulb 12Volt/20Watt required.
DUCTED
RECIRCULATED
Use manufacturer Product Code.
Use manufacturer Product Code.
1688
1744 Recirculation Kit
Extra lengths or bends may be required depending on the
length required & whether there is any structural material
in the run, eg rafters.
For optimal efficiency, use smooth ducting for reduced noise
and increased airflow. Flexible ducting should only be used
as a last resort.
For other Accessories, Parts or Service, please contact your local supplier or approved service agent
MAINTENANCE
Particular care should be taken with grease filter which must be periodically cleaned
(at least every two months). Remove the grease filters and wash them either by hand
or in the dishwasher using mild detergent. Caution: Never use products containing
abrasives (e.g. scouring pads, steel wool, abrasive liquid cleaner etc.) Use lukewarm
water and a mild detergent to clean stainless steel components. In high humidity and
coastal environments, cleaning should be carried out more frequently.
WARNINGS
• Care should be taken when removing filters in order to prevent the filter falling and
causing damage to the hob top.
• This appliance is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
• Upon installation the appliance must be positioned so that the plug is accessible.
• There should be adequate ventilation of the room when the rangehood is used at the same time
as appliances burning gas or other fuels.
• You must read the details concerning the method and frequency of cleaning.
• There is a fire risk if cleaning is not carried out in accordance with the instructions.
• Do not flambé under the rangehood.
• Exhaust air must not be discharged into an existing flue used for exhausting fumes from
appliances burning gas or other fuels.
• The recomended minimum distance between the hob surface and the lowest part of the range-
hood is 600mm. This should be increased to at least 650mm if installed over a gas hob.
We recommend 700mm.
• Attention should be given to ensure that any applicable regulations concerning the discharge
of exhaust air is fulfilled.
• If the supply cord of this equipment is damaged, it must only be replaced by the manufacturer
or it’s service agent, or a similarly qualified person in order to avoid a hazard.
