BA06040 - Saturn Swivelling Bath Chair
Assembly and Maintenance:
The following operating and maintenance instructions
must be observed:
• Check that the product has been delivered in
perfect condition before you use it.
• If you have any doubts about the restrictions on use, the adjustment or maintenance of the product,
please contact CareCo.
• Do not exceed the maximum operating load or the maximum load shown on the product label.
• Always ensure that the product is suitable for your requirements; in case of doubt, check with a
health professional.
• Worn, damaged or missing components must be replaced immediately by an approved repairer.
• Do not leave or store the product out of doors.
• Periodically check the stability and rigidity of the product and, where applicable, that the screws are
correctly tightened.
• Take particular care when using the product on damp surfaces.
1. Place seat upside down on a flat surface.
2. Insert the bath rests into the tubes underneath the seat - these can be adjusted to one of 3 settings
to suit the width of your bath. To adjust remove the bath rest adjustment pins and push the bath
rests into the tubes until they are level with the required hole. Once in place push the adjustment
pin back into the hole. (Please see the following page for reference)
3. Place the seat over the bath and into place, ensuring the bath rests on both sides are far enough
away from the edge of the bath to make them secure.
This shower chair has an adjustable base frame
to fit over the bath for range 737mm to 787mm.
Product Specifications (BA06040)
Seat Width
55cm
Seat Height
50cm
Max User Weight
113kg
