background image

INSTRUCTION GUIDE

Key Pad Entry Alarm

– HS4317

Congratulations on a wise purchase!

ENCLOSED YOU WILL FIND:

•  Key Pad Entry Alarm
• Magnet
• Double-sided tape
• Optional screws

TOOLS NEEDED:

•  Small flat head screwdriver
•  Small Phillips head screwdriver

FUNCTIONS

1. Announcing Visitors

Simply set the mode switch to “chime” for the electronic chimes to sound
when someone opens the door.

2. Alarm Mode

When you do not expect visitors, set the mode switch to “instant”. If someone
opens the door, a piercing alarm sounds for 90 seconds or until you enter the
security code.

Note:

After 90 seconds, the alarm resets to sound when the door opens. 

When you leave your house, open door, set the mode switch to “delay”, leave and
close the door. When you return, you must enter the security code within 8 sec-
onds, or the alarm sounds.
3. Panic Alarm

Press “panic” to immediately sound the alarm without opening the door. The
alarm sounds for 90 seconds or until you enter the security code.

Note:

After 90 seconds, the alarm resets to sound when the door opens.

4. Turning the Alarm Off
Simply set the mode switch to “off” to turn off the alarm and the electronic chimes.

Note:

• You can still use “panic” with the mode switch set to “off”.
• You cannot set the mode switch to “off” to silence the alarm. You must enter

the security code or wait 90 seconds for the alarm to stop sounding.

INSTALLATION

You must mount the alarm and magnet so the magnet rests with its arrow point-
ing toward one of the alarm’s markings for proper alignment. Choose a location
that lets you install the magnet on a door or window and the alarm immediately
next to it on the frame or vice versa. The distance between the alarm and the
magnet must be no more than 5/16 inch. Use the supplied screws or the supplied
adhesive tape and follow these steps to mount the alarm and magnet.
1.  Remove the two screws on the bottom of the alarm and remove the back

cover.

2. Use three of the five supplied long screws or two of the pieces of supplied

adhesive tape to mount the back cover. If using tape, make sure mounting
surfaces are free of dust, oil and other substances that could affect adhesion.

3. Connect 9-volt alkaline battery onto appropriate terminals.
4. Slide the alarm onto the back cover.
5. Replace the two screws on the bottom of the alarm.
6. Use the two remaining long screws or the other piece of the supplied adhe-

sive tape to mount the magnet so its arrow points toward one of the mark-
ings on either side of the alarm.

Note:

Set the alarm’s mode switch to Chime and open the door. You should hear

the electronic chimes. If not, readjust the position of the magnet.

SETTING THE SECURITY CODE

You can set your own four-digit alarm security code.
• Your alarm’s security code is preset to 1234 at the factory. Be sure you use a

different security code.

• You must enter all four numbers within 15 seconds, or the red indicator turns

off and the alarm exits the procedure and resets to the previous security
code.

•  If you remove the battery, the security code resets to 1234.

Follow these steps to set your own security code.
1.  Press CODE. The red indicator lights.
2. Enter the current security code. The red indicator flashes.

Reviews: