http://web.casio.com/ecr/app/
Quick Start Guide
1. To set memory protection bat-
teries
To prevent losing all your settings and sales data, we
strongly recommend that you set the memory protection
batteries before you use the cash register and replace
them at least once a year.
1.
Remove the printer cover by lifting it up.
2.
Remove the battery compartment cover.
3.
Note the (+) and (–) markings in the battery compart-
ment. Load a set of two new “AA” type alkaline
batteries so that their plus (+) and minus (–) ends are
facing as indicated by the markings.
4.
Replace the battery compartment cover and the
printer cover.
Important:
These batteries protect information stored in your
cash register’s memory when there is a power
failure or when you unplug the cash register. Be
sure to install these batteries first.
Warning:
No battery is included in the accessories.
Never try to recharge the batteries.
Do not expose batteries to direct heat, let them
become shorted or try to take them apart.
Keep batteries out of the reach of small children.
If your child should swallow a battery, consult a
physician immediately.
There is a risk of explosion if the batteries are
replaced with improper type.
2. To set a paper roll
The following explains for setting roll paper used as
receipts. If you wish to use the paper roll for journal (sales
record), please see page E-17 of the user’s manual.
1.
Open the platen arm by lifting it up.
Preparations
Note:
Please follow the steps described below.
Electronic Cash Register SR-S500/SR-C550
Electronic Cash Register can
be set by Smartphone Try it !
QSG240*E
Preparations
Note:
Please follow the steps described below.
2.
Ensuring the paper is being fed from the bottom of the
roll, lower the roll into the space behind the printer.
3.
Put the leading end of the paper over the printer.
4.
Close the platen arm slowly until it locks securely.
Please push the position marked [PUSH HERE].
Warning:
Never touch the printer’s thermal head and the
platen.
Avoid the thermal paper from heat, humidity or
direct sunlight.
Keep your hands off the paper cutter to avoid injury.
platen arm
platen
paper cutter
thermal head
5.
Replace the printer cover, passing the leading end of
the paper through the cutter slot. Tear off the excess
paper.
3. To turn the cash register on
1.
Insert a Mode key that comes with the cash register in
the Mode switch and turn it to
OFF
position.
PGM
2.
Plug in the power cord into an AC outlet.
