Use the three tightening screws located at the bottom
of each leg to secure the extended legs
in place.
To set up the tripod, spread the legs outward until
they are fully extended. Extend each of the three
tripod legs as far as they will go.
Quick Set-up Guide
1
2
3
All three legs should be the same length to provide a
level platform for the telescope.
4
7
Here is how the fully assembled tripod and mount
should appear.
5
Properly assembled, the accessory tray should appear
as pictured above.
6
Next slide telescope tube into the mount. Be sure to
back out fastening screws to allow enough clearance
for the dovetail.
8
Center dovetail in the mount and tighten fastening
screw. For added security tighten the angled lock
down screw next to the fastening screw.
9
Quick set-up guide for:
Model #21068 – SkyScout Scope 90
Your SkyScout Scope 90 includes: optical tube w/
attached SkyScout mounting bracket, pre-assembled
tripod with center leg brace and altazimuth mount
attached; two eyepieces; erect image diagonal,
finderscope and bracket, accessory tray, owner's
manual, and The Sky™ CD Software. SkyScout not
included.
To attach the accessory tray, line up the three tabs
and turn clockwise until tray tabs lock into place with
the tripod’s center leg brace.
Questions or Problems with Set-up?
CONTACT: Celestron Technical Support:
310
.
803
.
5955
www.celestron.com
Dovetail
Mount
Fastening
screws
