English
Set the time
1) Pull out the crown to the second click position.
2) Turn the crown to set hour and minute hand (Check that AM / PM is set correctly).
3) Push the crown back into the normal position.
*
If the crown is pulled to the second position while the chronograph is started, the chronograph hands will continue to
move. This is not a malfunction.
Set the date
1) Pull out the crown to the first click position.
2) Turn the crown clockwise for date setting.
*
Do not set the date between 9:00PM and 3:00AM, otherwise the day may not change properly. If it is necessary
to set the date during that time period, first change the time to any time outside it, set the date and then reset
the correct time.
3) Push the crown back into the normal position.
OPERATION MANUAL
# 17063R
TIME SETTING
Method 1
1) Set the crown to the normal position
2) Touch the AC terminal of circuit block and the switch spring with conductive
tweezers to reset the circuit.
3) The small second hand will move at two-second interval for 10 seconds as a
demonstration.
Method 2
1) Pull out the crown to the second click position.
2) Press the button B for two seconds and release the button.
3) Push the crown back to the normal position.
4) The small second hand will move at two-second interval for 10 seconds as a demonstration.
*
If the crown is operated within these 10 seconds, the two-second interval movement will not be activated.
*
It is not necessary to set the chronograph hands after the battery is exchanged. If the chronograph hand positions are
incorrect, following below procedure all the chronograph hands will be reset to "0" position
Button A
Button A
Button B
(START)
(STOP)
(Reset)
HOW TO RESET (AFTER BATTERY CHANGE)
