ORIGINAL INSTALLATION & OPERATING INSTRUCTIONS
The Herschel Aspect XL consists of 2 or 3 highly emissive ceramic heating elements mounted in a directional, reflective unit. It is designed
to gently warm people using infrared heat. Infrared Heat is a 100% natural radiating heat that humans readily absorb, producing a feeling
of great comfort and well-being. Infrared Heat produced from the Herschel IR warms you directly without heating the air in between :
meaning the heat goes where you want it.
The system is easy to install; extremely discreet, produces no red light and requires next to no maintenance.
CAUTION:
The Herschel Aspect XL rises to very high temperatures in use and the unit (in particular the ceramic surfaces) must not be touched when
power is applied. Do not touch the unit when this is on. After switch off the elements remain hot for a considerable time and the unit should
not be touched within 30 minutes minimum after heater has been switched off.
Please attach the supplied notice (CAUTION DO NOT TOUCH HEATER) to the wall near the heater or in a location where it can easily be seen.
Never use the heater to ignite materials.
Particular attention has to be given where children and vulnerable people are present. The Aspect XL is not to be used by children or persons
with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given instruction or are
under supervision. Children of less than 3 years should be kept away unless continuously supervised. Children should be supervised to ensure
they do not play with the appliance.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or
perform user maintenance.
To avoid a fire hazard, do not cover the heater in any manner and ensure there is adequate air circulation around the heater. The Appliance
shall, under no circumstances, be covered with insulating material or similar material.
The heater must not be used if the Ceramic panels are damaged. If the power supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
WARNING:
This heater is not equipped with a device to control the room temperature. Do not use this heater in small rooms when they are occupied by
persons not capable of leaving the room on their own, unless constant supervision is provided.
IMPORTANT INFORMATION:
Please read the following information fully, as safe and reliable operation depends on correct installation. Please keep this instruction sheet
for future reference.
The AC mains supply is dangerous and potentially lethal. Ensure the mains supply is switched off at the consumer unit (fuse box) before
attempting any work on electrical circuits. Wiring to this unit must be connected in accordance with the relevant national electrical safety
standards. This unit must only be installed by a competent and qualified electrician. This appliance must be earthed.
Do not disassemble : no user-serviceable parts inside.
ELECTRICAL INFORMATION:
The electrical supply to the unit should be provided by connecting to a circuit, which is protected by a fuse or miniature circuit breaker suitable
for the electrical rating of the unit and in accordance with Table 1 or Table 2. The supply to the heater must be switched separately using a
switch appropriately rated for the load and supply voltage. A switched fused spur may also be used on existing ring main circuits where the
Wall-mounted Infrared Heaters
IPX4 rated (ceramic elements)
MODEL: AXL2/0416 AXL3/0416
HERSCHEL ASPECT XL2 -
HERSCHEL ASPECT XL3
IPX4
XL2/XL3 V1.6 260416
XL2/XL3 V1.6 260416 Page 1
