CHANGE AN EXISTING PIN
1
? ? ? ?
Press the programmed PIN
that you want to change.
...the light bulb
blinks twice.
2
Press and hold the
# button until...
3
+
? ? ? ?
new PIN
Enter the new 4-digit PIN of your choice,
then press the ENTER button.
4
To test, press the new PIN,
then the ENTER button.
The garage door opener
will activate.
The light bulb will blink once.
2
Enter a 4-digit
personal
identification
number (PIN)
of your choice:
3
4
1
Locate the
Learn button
on the garage
door opener.
? ? ? ?
Press and hold the ENTER
button until...
...the light bulb blinks.
Press and
release the
Learn button.
The LED will light.
Within 30 seconds...
PROGRAM INITIAL PIN - using the Learn button
PROGRAM INITIAL PIN - using a multi-function door control*
Press the LEARN button again,
the LED will flash once.
Press the LEARN button on the door
control to enter Programming
Mode.
The command
LED will flash once.
The command
LED will flash
once again.
Enter a 4-digit
personal
identification
number (PIN)
of your choice:
? ? ? ?
4
..the light bulb blinks.
Press and hold the ENTER button until...
For use with MyQ™ Garage Door Openers. The garage door
opener activates when the 4-digit Personal Identification
Number (PIN) and ENTER button are pressed on the Keyless
Entry.
Install the battery and program the Keyless Entry prior to
installation. Make sure the garage door opener has a
working light bulb because it is a programming indicator.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and
away from ALL moving parts of door.
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
®
WIRELESS KEYLESS ENTRY • MODEL 940ESTD
*Optional accessory
To test, press the PIN, then press the ENTER button. The garage door opener will activate. To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN
for each additional garage door opener.
Summary of Contents for MyQ 940ESTD
Page 7: ...NOTES...
