Instructions for Chelsea Shipstrike Clocks
MECHANICAL
MECHANICAL
MECHANICAL
MECHANICAL
::::
1.
1.
1.
1.
To Start
To Start
To Start
To Start
Your clock leaves the Chelsea factory fully wound.
Remove the black tube from the winding arbor (Save and
replace tube when you are shipping the clock or are away
for long periods of time.) Although full cycle is 8 days, it
is recommended that you rewind your clock weekly.
2.
2.
2.
2.
To Set
To Set
To Set
To Set
The Shipstrike clock may be set forward or backward. To
set, remove bezel and glass assembly and manually move
the minute hand to correct time. The hour hand should
not be touched during the setting operation. Once the clock has been set, it
will automatically start to run.
3.
3.
3.
3.
Regulate
Regulate
Regulate
Regulate
The Chelsea Shipstirke clock was regulated to provide high accuracy in
timekeeping. If, due to influences in transit, regulation is felt necessary, the
following precautions should be taken. Regulator tab is on the dial near the 1
o’clock position.
1.
Run the clock for one week to stabilize timekeeping before attempting
regulation.
2.
Regulate only a small amount at a time.
3.
To make clock run faster, move regulatory lever so slightly toward F
(Fast). To make clock run slower, move regulator lever so slightly
toward S (Slow).
4.
Stop Strike
Stop Strike
Stop Strike
Stop Strike
The striking mechanism may be shut off by moving the tab near the 11 o’clock
position, move away from the bell symbol. DO NOT shut off the strike while
the clock is striking.
QUARTZ
QUARTZ
QUARTZ
QUARTZ ---- STRIKING
STRIKING
STRIKING
STRIKING::::
Your Quartz Shipstrike clock is powered by two AA size
alkaline batteries, adequate to operate the unit for an average
of 6 months.
1.
1.
1.
1.
Movement Access
Movement Access
Movement Access
Movement Access
a.
Unscrew the bezel from the front of the clock and
carefully set aside.
b.
Remove the dial and attached movement from
the case, being careful not to pull out or damage
