background image

1224 East Warner Ave, 

Santa Ana, Ca 92705 

Tel: 1-714-545-5511 

www.cherryaerospace.com   

TS-H83HL-6MB  Rev: A   Date: 05/04/11    CR: 11-0486

 

H83HL-6MB 
PULLING HEAD FOR -6 DIA 130° MAXIBOLT

TM

 TITANIUM FLUSH HEAD

 

Technical Data Sheet

, Page 1 of 2

 

 

  

DIMENSIONAL DATA 

(all measurements in Inches, see figure 1)

 

 

Tool Weight (without riveter): .33 Lbs (.150 Kg).  

 

 
 
 

CHOICE OF RIVETERS 

 

G83 or G84 Cherry® Riveters 

 

May be used with G84-LS Cherry® split riveters; use with adaptor 744-700. 

 

MOUNTING INSTRUCTIONS 

 

Attach riveter to air source for correct piston positioning; on the hand riveters, make sure that the pressure has 
been released and that the correct adaptors are used. 

 

Push against the riveter piston and thread collet assembly onto the piston. 

 

Snap sleeve assembly onto riveter bayonnet mount.  

 
USAGE 

 

This tool was designed to install -6 Diameter 130° Titanium Maxibolt

TM

 flush head fasteners (CR7774S-06).  

 

BEFORE USE, MAKE SURE THAT: 

 

The correct pulling head is used and is properly mounted on the recommended riveter. 

 

Proper air source is connected (see riveter specification for recommended pressure). 

 

Make sure that the tool is clean and in good working condition 

 

Make sure that the nut is snug against the Polyurethane Spring (item 11); do not over-tighten. 

 

DURING OPERATION 

 

Inspect the active area of the nosepiece regularly. 

 

Keep the tool clean, especially the nosepiece and jaws; pay special attention when sealants are used. 

 

If stem slippage occurs, the Jaws need to be either cleaned or replaced. 

 
PREVENTATIVE MAINTENANCE

 

 

Clean the Insert, jaws and jaw cavity every 1,000 installations, or whenever failures occurs.  

 

Lubricate outside configuration of the jaws with Lubriplate® or similar light lubricant. 

 

Inspect regularly and keep the active area clean and in good working condition. 

 

Replace worn or broken components. 

 

ASSEMBLY / DISASSEMBLY PROCEDURE

 

Caution: Use Loctite® 242 on the threaded elements 
 
Collet Assembly 
Grease the tapered area of the Jaws with Lubriplate®. 
Assemble as shown in the exploded view; make sure the jaws 

(2) are properly aligned.

Figure 1 

Reviews: