background image

Installation Guide

Diluvio™ Underwater Loudspeaker

Installed in a Hayward Face Rim

This procedure uses the following parts:

•  Diluvio™ Underwater Loudspeaker

•  Hayward Stainless Steel Face Rim, Part Number SPX0580AS

•  Hayward Assembly Clamp with Screw, Nut, and Washer, Part Number SPX0580BS 

•  Hayward Face Rim Lockscrew, Part Number SPX0980Z3

Summary of Contents for Diluvio

Page 1: ...a Hayward Face Rim This procedure uses the following parts Diluvio Underwater Loudspeaker Hayward Stainless Steel Face Rim Part Number SPX0580AS Hayward Assembly Clamp with Screw Nut and Washer Part Number SPX0580BS Hayward Face Rim Lockscrew Part Number SPX0980Z3 ...

Page 2: ...eaving the 1 inch 2 54 cm gap in the rubber ring exposed 3 Reinstall the screw nut and washer in the assembly clamp 4 1 Carefully place the Hayward face rim chrome side down on a non abrasive surface and place the speaker and assembly clamp on the Hayward face rim 5 Align the assembly clamp screw so that it does not cover the mounting tab or the face rim lockscrew Once aligned tighten the assembly...

Page 3: ... applications the niche will already be mounted in the wall of the pool 3 Take the end of the speaker wire and pull it through the conduit hole in the back of the niche using a wire puller 9 Leave 10 to 12 ft of wire in the niche to allow for easier access during future servicing of the speaker 10 4 Diluvio INSTALL HAYWARD FACE RIM Page 3 of 4 Underwater Speaker Hayward www clarksynthesis com ...

Page 4: ...te located on the bottom of the niche 12 Align the lockscrew on the face ring with the threaded receiving hole on the niche 13 Attach the trim ring securely to the niche by gently tightening the screw 14 You are now ready to connect the speaker to your audio system 5 11 12 Diluvio INSTALL HAYWARD FACE RIM Underwater Speaker Hayward Page 4 of 4 www clarksynthesis com ...

Reviews: