CleanSweep
®
Power Distribution Unit (PDU)
with EMI Filtering and
Advanced Transient Surge Protection
AREC144FG
User’s Guide
PDU Care
Normally, PDU requires no maintenance and no calibration. It is recommended,
though, to periodically inspect PDU for overheating.
During its normal operation PDU may have elevated temperature which would feel
“
warm
”
to the touch, but not what is considered
“
hot.
”
If the PDU does feels
“
hot
”
to the touch (more than 70
0
C or 158
0
F), turn off PDU and disconnect equipment that
is powered by PDU immediately. First, verify that the total current load does not
exceed PDU
’
s maximum rating. Keep in mind that sometimes stated power rating of
equipment is
“
typical
”
rather than
“
maximum
”
-
it is prudent to load PDU to no more
than 75% of its capacity to accommodate for such situations. Then, check if the heat
dissipation of the PDU is obstructed by improper installations such as objects placed
on its top or lack of space around it for proper ventilation, or its placement in a small
confined space. If such problem is identified, correct it, let the PDU cool down and
turn it back on. Check within 30 minutes and then within an hour the temperature of
the PDU. If the PDU still feels
“
hot
”
to the touch, turn PDU off, disconnect your
equipment, and discontinue using PDU. For warranty or other repair contact factory
or its authorized distributors.
Life Critical Applications
OnFILTER products shall not be used in life
-
critical or mission
-
critical applications.
While OnFILTER believes it designs and manufactures very reliable products, many of
the vendors that OnFILTER sources components from do not recommend or endorse
the use of their products in life–
or mission
-
critical applications. By extension,
OnFILTER must adhere to the same business policy.
Disclaimer
OnFILTER products are not designed, intended, authorized, tested, or listed for use in
systems intended to support or sustain life, or for any other application in which the
failure of an OnFILTER product could create a situation where personal injury or
death may occur. Should Buyer purchase or use OnFILTER products for any such
unintended or unauthorized application, Buyer shall indemnify and hold OnFILTER
and its officers, employees, subsidiaries, affiliates, agents and distributors harmless
against all claims, costs, damages and expenses, and reasonable attorney fees aris-
ing out of, directly or indirectly, any claim or personal injury or death associated with
such unintended or unauthorized use, even if such claim alleges that OnFILTER was
negligent regarding the design or manufacture of the part.
OnFILTER, Inc.
730 Mission Dr. Ste. 102
Santa Cruz, CA 95060 U.S.A.
Tel. +1.831.824.4052
FAX +1.206.350.7458
www.onfilter.com
info@onfilter.com
©
2017
On
FI
LTE
R, I
nc
. Al
l ri
gh
ts res
erved
. C
lean
Swe
ep is
a
reg
ist
ere
d t
ra
dem
ark
o
f On
FI
LTE
R, I
nc
. PU
B03701
All specifications are subject to change without notice. Patents Pending. Made in U.S.A.
8
w
w
w
.on
fil
te
r.c
om
