Quick Start Guide
ClearCube Technology
8834 Capital of Texas Hwy N Austin, Texas 78759
voice 512 652 3500 www.clearcube.com
USB 1.1 Ports
Power Indicator LED
Link Indicator
Power Button
ClearCube® C7420 Digital Fiber C/Ports provide the following:
•
LC fiber optic connector
•
Support for one or two independently–configurable monitors
•
PC–over–IP™ (PCoIP™) processors, delivering PC video and
audio over your IP network
•
Four USB 1.1 ports
•
Audio in and audio out
C7420 Digital Fiber C/Port Overview
In typical ClearCube environments, PC blades are centrally–
located in data centers. Each blade user has a user port (such as a
C7420) on their desk, which has a network connection to a PC
blade. A C7420 provides the interface to the blade. That is, the user
can connect monitors, pointing devices, and other peripherals to
the C7420 to receive peripheral data sent from a blade and to send
USB data to the blade.
The C7420 securely extends user desktops from centralized PC
blades. This point-to-point fiber optic solution supports existing
fiber cabling infrastructures that employ a pair of multi-mode
fibers for each user. The C7420 connects to a F6150 fiber
transceiver chassis using a pair of 62.5µ or 50µ, multi-mode fibers
through an LC connector.
Setting up Your C7420 Digital Fiber C/Port
Perform the following steps to set up the C7420 Digital Fiber
C/Port. To mount the C7420 under a desk, use a 9/64–inch drill bit
to drill pilot holes for the mounting bracket screws.
1.
Place your C7420 on a desk or use the included mounting bracket to
mount the C7420.
–
Ensure that there is a minimum of 1.5 inches of clearance
on each side of the C/Port, and a minimum ¾–inch
clearance above the C/Port.
–
To prevent overheating, do not stand the C/Port on either
of its sides, and do not cover any ventilation holes.
–
When using the C7420 mounting bracket to mount the
C/Port under a desk, use the holes on the top of the bracket
as a hole pattern to drill holes. Ensure that the bracket is
inset 1.5 inches from the front of the desk.
2.
Connect the following to the C7420:
–
USB keyboard and pointing device using the USB ports on
the front or the rear of the C7420.
–
LC fiber optic cable to the LC jack on the rear of the C7420.
–
Monitor cable to each DVI-I port on the rear of the C7420.
–
Power adapter supplied with the C7420
C7420 Digital Fiber C/Port
Fiber Connection
C7420
Digital Fiber C/Port
Network Switch
F6150–160
Sentral Switch
Sentral
Fiber Transceiver
Chassis and Blades
Peripherals
USB 1.1
Ports
Audio In
Audio Out
DVI–I
Port 1
DVI–I
Port 2
Power
Connector
LC Fiber
Reset
Button
Fiber
Activity
