CE-HD04M
User Guide
HD-SDI Multiplexer
The CE-HD04M Multiplexer enables four HD-SDI signals to be viewed, sequenced
and output to a single HD-SDI source, as well as an HDMI source.
INSTALLATION:
1.
Connect the four HD-SDI cables coming from the cameras to the HD-SDI Inputs. Limit each cable distance to a maximum of 275 feet.
2.
Connect the HD-SDI cable from the DVR (or HD-SDI monitor) to the HD-SDI Output. Limit this cable distance to a maximum of 275 feet.
3.
To view on an additional monitor, connect an HDMI cable from the monitor to the HDMI Output. Limit this cable distance to a maximum of 25 feet.
4.
Using the HDMI Resolution Dial, select the desired HDMI display resolution. The output resolution of the device can be found within the resolution setting in the device’s
OSD.
NOTE: Resolution should be set to 1080p 30 if connecting to a DVR. Higher frame rates will result in video loss at the DVR.
5.
Connect a DC12V 0.5A power supply (sold separately) to the power input.
*Distances shown are recommended maximums.
HDMI Resolution
0
12
3
4
5
67
89
AB
C
D
E
F
CONNECTION DIAGRAM:
HD-SDI
INPUTS
6
7
0
1
2
F
4
5
DC12V 0.5A
POWER
CONNECTION
HDMI
OUTPUT
HDMI
RESOLUTION
DIAL
BLINKING GREEN LED:
Good HD-SDI Input Signal,
Current signal being shown on-screen
SOLID GREEN LED:
Good HD-SDI Input Signal
RED LED ON:
Poor HD-SDI Signal
RS485
INPUT
SERVICE PORT
(not user serviceable)
HD-SDI
OUTPUT
HD-SDI DVR (4ch)
HD-SDI
CAMERA
HD-SDI
CAMERA
HD-SDI
CAMERA
HD-SDI
CAMERA
DC12V
1
2
3
4
ch1
ch2
ch3
ch4
1
2
3
4
HDMI MONITOR
HDMI
HD-SDI
cam 1
cam 2
cam 3
cam 4
25’
M A X
275’
M
AX
275’
M A X
Resolution should be set
to 1080p 30 if connecting
to a DVR. Higher frame
rates will result in video
loss at the DVR.
