STITCH LINE
2-POLE SUN SHADE
MODEL 2000001653
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or sharp objects, to install your sun shade.
WARNING: Keep clear of overhead power lines.
• Do not set up your
sun shade
under trees because of potential lightning strikes or falling tree limbs in inclement weather.
• Secure with
all
stakes and guylines provided to prevent property damage or personal injury.
• For best results in windy conditions, position narrow end of sun shade into the wind.
• Enlist the help of at least one other person to assist you when it is time to assemble the
sun shade
.
• Under no circumstance should this product be used to cover automobiles, marine products or similar.
Metal Poles (2) – Part No. 5010000658
ASSEMBLY PARTS
Sun Shade Assembly
1.
Assemble the two shock-corded support poles. (Fig. 1)
2.
Insert narrow metal tip on pole into metal grommet located on the
web strap of the long end of the sun shade. (Fig. 2)
3.
Lift pole to upright position; then extend out the guylines tied onto
theweb strap. (Fig. 2)
4.
Slip loop on each guyline over plastic stake and drive in at a slight
angle to secure. (Fig. 3)
5.
Repeat steps 3 & 4 above for the remaining support pole and guylines.
6.
Extend out remaining guylines and each corner of the sun shade until
taut and secure with plastic stakes. (Fig. 2)
(continued on other side)
Sun Shade (1)
Grommet
Grommet
Guyline
Pole Tip
Fig. 1
Fig. 2
Fig. 3
Grommet
Guylines
Metal Pole
MODEL 2000002626
