Comfort
Heat
Australia © 2020
www.
comfortheat
.com.au
Comfort
Heat
Hydronic & Electric Floor Heating Systems
MTD3 MANUAL
CABLE WARRANTY & SUGGESTED FLOOR TEMPERATURES
A Comfort Heat floor heating system has been installed in your floor. Floor heating warms from the
ground up providing an unparalleled feeling of comfort. This heating system is controlled by an
electronic thermostat and floor sensor for optimum temperature control and efficiency.
PRIOR TO TURNING ON
Concrete slabs, screeds and tile glues must be fully cured before turning the heating system on. Wait at least 3 weeks and
when turning on for the first time, increase the floor temperature gradually over 2-3 days.
Under carpet and timber systems can be turned on once installation is complete.
AREAS
TILE [BATH]
TILE [LARGE AREA]
INSLAB
CARPET
TIMBER
SUGGESTED TEMPERATURE
24-28ºC
21-22ºC
21ºC
19-21ºC
24ºC
CABLE WARRANTY
10 years
10 years
10 years
5 years
5 years
MTD3 DETAILS
The MTD3 thermostat is a manual ON/OFF thermostat you set to a fixed temperature. Once the floor reaches the set
temperature, the system will turn ON and OFF automatically maintaining the fixed temperature.
TECHNICAL DATA - MTD3
Supply Voltage: 240VAC, 50/60hz
Output Relay: 16A SPST, 3600W max
Switching Differential: 0.4 degC
Built-in Switch: 2 pole 16A
Temperature Range: 0/+40 degC
Housing/protection: IP21
Dimensions (HxWxD): 115mm x 84mm x 40mm
Sensor Length: 3m
Mounted: Vertical/Horizontal Flush mounted
Warranty: 2 years
