© 2019 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or
™ are registered trademarks or trademarks, respectively, of CommScope, Inc. A997-0086 G (5/19)
Page 1 of 8
A997-0086 Revision G, May 2019
F-042-GL-E, T-045-GL-E & T-041-GL-E For
Dual Band 33° Beamwidth Panel Antennas
General
This instruction sheet contains all necessary information required to assist in the correct
installation of the Large Dual Band 33° Beamwidth Panel Antennas. These antennas are
supplied with AISG-compatible remotely controlled electrical beam downtilt (RET). Mechanical
downtilt is also available if required, depending on the type of mounting kit selected.
Following symbols can be found next to text outlining important information.
Please follow the procedure marked with this symbol precisely.
Non-compliance may lead to damage of the product.
Handy tips when installing product.
Unpacking
Make sure that the antenna and the accessory items listed below are provided and have not
been damaged during transport.
•
Antenna
•
Mounting kit (mounting kit components for each configuration is shown in Figure 3, 4, 5,
7 & 8).
DO NOT STACK
UNPACKED
ANTENNAS
