background image

Contents

1 General

2  Kit contents

3 Installation

 
 

3.1 General

 

3.2 FIST-GCO2-BX

 

3.3 FIST-GCO2-FX

1   General

This kit is used to install 1 drop cable of 11 to 14 mm diameter in a 
new unused round port of the FIST-GCO2-BX and FX.

Comment

: depending on outside conditions, some oil bleed-out may 

occur. This will not affect in any way the sealing performance.

FIST-RSKG-1

I N S T A L L A T I O N   I N S T R U C T I O N

Gel seal for the round cable ports of FIST-GCO2-BX and FX 
splice closure

2    Kit contents

Kit content FIST-GCO2-BX6

Kit content FIST-GCO2-FX/BX8

Note

: The lubrication oil in the kit makes it easier to

- install gel-seal in the closure ports
- guide cables through ports in the gel-seal.

Overview of the available types of gel seals.

3.1.1  Before installing the gel seal in the port, install the 2 securing 
screws.

3   Installation

3.1  

General

Thermoplastic gel seals

Number of ports

Cable range (mm)

1

11-14

2

8-11

3

6,5-8

4

4-7

8

3-5

16

0-3

FOSC-OSKG

6-15

FIST-OSKG

5-18

FIST-OSKG20

16-20

TC-907-IP
Rev C, November 2018
www.commscope.com

CX5496-000

Rev D

Summary of Contents for FIST-RSKG-1

Page 1: ...e round cable ports of FIST GCO2 BX and FX splice closure 2 Kit contents Kit content FIST GCO2 BX6 Kit content FIST GCO2 FX BX8 Note The lubrication oil in the kit makes it easier to install gel seal in the closure ports guide cables through ports in the gel seal Overview of the available types of gel seals 3 1 1 Before installing the gel seal in the port install the 2 securing screws 3 Installati...

Page 2: ...ates to the frame Make sure that it is positioned at the center of the port Do not tighten the screw completely Secure the cable jacket with the hose clamp at the T shape Secure the strength member between the 2 metal plates and tighten the screw Route the loose tubes as per standard practice 3 1 2 Open the port The cutting wire can be used Make sure that the edges are free of burrs Install the se...

Page 3: ...ble jacket Feed the cable through the gel seal Apply some tape at the end of the loose tubes to ensure easy feeding through the gel seal 3 3 2 Secure the metal bracket to the frame bottom hole with the screw M5 Secure the cable jacket with the hose clamp at the T shape If needed use some tape or foam to build up the diameter Secure the strength member between the metal plate and bracket and tighte...

Page 4: ... screws This allows cables to be secured outside the closure C2 Apply some foam to the cable s and secure with tie wrap s to the frame Visit our website or contact your local CommScope representative for more information www commscope com All trademarks identified by or are registered trademarks or trademarks respectively of CommScope Inc 2018 CommScope Inc All Rights Reserved This product may be ...

Reviews: