Page 1
Quick Start Guide
GS-7260| 5-Port Gigabit IGMP Switch
Understanding your IGMP Switch
This switch contains LEDs to show the activities and status of the ports, including power LED and Link/ Act LEDs.
Please refer to the front panel of the switch for the positions of the LEDs :
Look at the following table for the description of the LEDs:
LED
Status
Operation
Power
Steady Green
The switch is powered on
Off
The switch is powered off
Link/ ACT
1-5
Steady Green
1000Mbps connected
Amber
10/100Mbps connected
Blinking
Sending or receiving
Off
Port disconnected or link fail
Rear Panel
Basic Setup
(Note: This switch only supports IGMP v1 & v2)
1.
Connect the A/C power adapter to a power outlet, then connect it to the Power Socket of the switch.
The power LED turns on when the switch is receiving power.
2.
Connect your xDSL / cable modem to Port 1 of the switch by Ethernet cable.
3.
Connect your computers and network devices (Ex. Set-Top-Box, DVR, etc.) to any available port on the switch.
A
Ethernet Ports
Power
Socket
B
