Condar Fireplace
Rod and Valance Kit
Installation Instructions
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Push adjustable valance extensions all the way
inside the central valance to make whole valance
its minimum width (31.5 inches).
Align valance in center of your firebox. Be sure
front of the valance is flush with outer edge of
firebox and that the two center holes face the roof
of your firebox. Mark the location of the two holes
with a pencil.
Drill two pilot holes on the two pencil marks
using a 3/16 inch masonry drill bit. If your firebox
has a metal lintel, first drill a 1/4 inch hole
through the metal.
Place valance back in the center of your firebox.
Secure in place with two blue tapcon screws.
Once valance is screwed in place, slide one
valance extension outward until it meets the
inner wall of firebox. Mark hole at the end of
extension with a pencil.
-Tape Measure
-Pencil
-Drill
-3/16 inch masonry drill bit
-1/4 inch drill bit (required for fireboxes with
metal lintel)
-Flat head screwdriver
Rod & Valance Kit Includes:
Tools needed for installation:
