background image

 

1

 

 

Installation & Control Guide for SLPIR 

Motion Detection Wireless Controller

 

All  electrical  appliances  produced  by  the  Company  are  guaranteed  for  one  year  against  faulty  materials  or 

workmanship.    This  applies  only if  the appliance has been  used  for  purposes in accordance with  the instructions 
provided and has not been connected to an unsuitable electricity supply, or subject to misuse, neglect, damage 
or modified or repaired by any person not authorised by us. This guarantee is offered to you as an extra benefit and 
does not affect your legal rights. 

 
The correct electricity supply voltage is shown on the rating label attached to the appliance. 
 
Reasonable  care  has  been  taken  to  ensure  that  this  guide  is  accurate  at  the  time  of  printing.  In  the  interest  of 

progress the Company reserve the right to vary specifications from time to time without notice.

 

SLPIR C

ONTROLLER

  

13984111 Iss 01 

C

USTOMER

 H

ELPLINE

 

 

Should you need any advice on the use of your new Consort product, please contact our Helpline: 

 

Consort Equipment Products Limited 

Thornton Industrial Estate, Milford Haven, Pembrokeshire, SA73 2RT 
Tel: 01646 692172   Fax: 01646 695195   Email: technical@consortepl.com   Web: www.consortepl.com 
Operation hours: Mon to Thu 8.30am to 4.30pm | Fri 8.30am to 3.30pm 
BS EN ISO 9001 Registered Company No FM12671 

Summary of Contents for SLPIR

Page 1: ...ghts The correct electricity supply voltage is shown on the rating label attached to the appliance Reasonable care has been taken to ensure that this guide is accurate at the time of printing In the interest of progress the Company reserve the right to vary specifications from time to time without notice SLPIR CONTROLLER 13984111 Iss 01 CUSTOMER HELPLINE Should you need any advice on the use of yo...

Page 2: ...nts around the sensor show remaining time Each segment equals 1 4 of the total time Switch 3 4 OFF 5 minutes Switch 3 ON 15 minutes Switch 4 ON 30 minutes Switch 3 4 ON 60 minutes 3 Presence detection with Timer To set ON time period after the motion was detected the switches are set as shown below 60 MINS 45 MINS 30 MINS 15 MINS Controller functionality After the motion detection the controller a...

Page 3: ...red and green Temperature control for the comfort period To enable temperature control the switch 1 is set to ON position as shown below The temperature control is only active after motion detection and will end after the set time period ends After the set time period ends the tem perature is allowed to fall If the room temperature is higher than the set comfort temperature the heating will not be...

Page 4: ...Power ON the controller or controller and heater together Wait 2 seconds Power OFF the controller or controller and heater together Wait 2 seconds Power ON the heater Power ON the controller If the sequence was followed correctly the 4 light segments will flash yellow to indicate pairing After the pairing is finished the light segments will change to green If the pairing was successful the applian...

Reviews: