™
Warnings and Considerations
WARNING!
Turn OFF electrical power before installing or servicing this
product. Improper use or installation can cause SERIOUS INJURY, DEATH
or LOSS/DAMAGE OF PROPERTY.
WARNING!
This device must be protected by a circuit breaker (20A max).
WARNING!
Ground this device in accordance with the National Electric
Code (NEC) requirements. DO NOT rely solely upon the yoke plate’s
contact with a metal wallbox for adequate grounding. Use the device’s
ground wire to make a secure connection to the safety ground of the
electrical system.
IMPORTANT!
This device must be installed by a licensed electrician in
accordance with all national and local electrical codes.
IMPORTANT!
If you are unsure about any part of these instructions,
consult a qualified electrician.
IMPORTANT!
Use this device only with copper or copper-clad wire. Do
not use aluminum wiring. This product has not been approved for use with
aluminum wiring.
IMPORTANT!
Using this product in a manner other than outlined in this
document voids your warranty. Further, Control4 is NOT liable for any
damage incurred with the misuse of this product. See “Troubleshooting.”
IMPORTANT!
Do NOT use a power screwdriver to install this device. If you
do, you may overtighten the screws and strip them. Also, overtightening
the screws may interfere with proper button operation.
IMPORTANT!
This is an electronic device with intricate components.
Handle and install with care!
Installation Instructions
1
Ensure that the location and intended use meet the following criteria:
•
When replacing a traditional 3-way switch, refer to the “Two-Location”
sample wiring configurations provided in the appropriate load control device
installation guide.
•
Install in accordance with all national and local electrical codes.
•
The range and performance of the wireless control system is highly
dependent on the following: (1) distance between devices; (2) layout of the
home; (3) walls separating devices; and (4) electrical equipment located near
devices.
2
Turn off the mains electrical power at the consumer unit. To ensure the wires
do NOT have power running to them, use an inductive voltage detector.
NOTE:
The wallbox wiring shown in this document is an example. Your
wire colors and functions may differ. If you are not sure which wires are
the Hot, Neutral, and Ground wires, have a trained electrician do the
installation.
3
Prepare each wire. Wire insulation should be stripped back 7mm from the
wire end (see Figure 1).
Supported Model
•
C4-KC240 Wireless Configurable Keypad, 240V
Introduction
The Control4® Configurable Keypad is intended for use in a Control4 system. It
installs in a standard wallbox using typical wiring standards and communicates to
the Control4 system using a wireless connection.
Box Contents
• Configurable
Keypad
•
Keycap Button Kit
• Terminal
Block
• Warranty
Card
•
Configurable Keypad Installation Guide
(this document)
•
Keypad Buttons Installation Guide
Specifications
The specifications are described below.
Model Number
C4-KC240-xx
Power Requirements
220VAC-/-10% 50/60 Hz
36-48VDC
This device requires a neutral AC
connection.
Power Consumption
240V: 480mW
36VDC: 430mW
Environmental
Operational Temperature
32˚ F - 104˚ F (0˚ C - 40˚ C)
Humidity
5% to 95% non-condensing
Storage
-4˚ F - 158˚ F (-20˚ C - 70˚ C)
Miscellaneous
Control Communications
ZigBee, IEEE 802.15.4, 2.4 GHz, 15-channel
spread spectrum radio
Wallbox Volume
4.75 cubic inches (77.8 cubic centimeters)
Weight
0.12 lb. (0.05 kg)
Shipping Weight
0.18 lb. (0.08 kg)
Configurable
Keypad
Installation Guide
