CS108 RFID Handheld Sled Reader
Quick Start Guide
2D Barcode Scanner Module (Optional)
RFID Reader Antenna
RFID Power On Status Light
Status Light
Barcode Power On Status Light
Charging Status Light
External Power Status Light
SUMMARY OF VIEW
1
2
3
4
5
6
7
2
1
7
5
3
4
6
This guide provides simple steps to to let you quickly
start using your new CS108 RFID sled handheld reader.
1. Open Box and Check Contents:
2. Install the battery (see pictures of Battery Insertion)
3. Initial Charging of the CS108:
CS108
RFID Sled Handheld Reader
CS108B
battery
CS108USBCtoACable
USB Type C to USB Type A cable for
connecting CS108 to PC or charger
CS108QSG
Quick Start Guide
It is important to fully charge the unit before using it the first time. It takes
approximately 4 hours to be fully charged. Please refer to the diagrams for battery
installation. After Inserting the battery into CS108, connect the supplied USB Type C
plug to CS108 and connect the Type A plug into any USB charger. The RED charging
LED will light. Charge the unit until the red light goes out.
1
1
10
2
3
4
BATTERY INSERTION
Replace the battery cover. Make sure that the locking tabs at
the front of the battery cover are fully inserted into the slots as
shown in the below diagram.
The below image shows the battery in its position. The battery
should be fully secured by the battery spring-loaded clip as
shown.
To access the battery compartment, remove the battery cover by:
First fully rotate to release the metal latches at both sides of the battery cover;
Then slide horizontally out to release the battery cover.
1
1
2
1
3
4
2
To insert the battery pack into the battery compartment:
The metal contacts at the bottom side of the battery must face down to
meet the metal contacts as shown on the below diagram.
Make sure that the locking tabs at the front of the battery are inserted into
the slots as shown in the detailed diagram.
2
1
1
2
2
