STITCH LINE
9 PERSON LIGHTED INSTANT CABIN TENT - 14 x 9
Model No. 40062-1
1
Prepare for Setup
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to set up your tent.
• Remove all contents from bag.
• Unfold (6) leg poles from the pod shape. Unfold legs again at
joints, to lay tent þat. Center will stand up.
Two people can easily setup this instant tent in 60 seconds or less.
Contents & Repair Parts:
Center Hub #90491
Corner Joint
#91150
#91242
2
Lift Roof and Eave Poles
•
• Grab roof poles and pull straight out to create tent’s cabin shape
(leg poles will angle at joints to partially stand up).
Side Hub #90138
LED Roof Pole #91881
LEG POLE
LED ROOF POLE
Not Pictured:
Awning Pole #91181
Carry Bag #91182
Rainþy #91183
Reþective Guyline
#91221
Battery Compartment
#91225
Extend Leg Poles
NOTE:
DO NOT extend telescoping
poles until all legs and ceiling hubs are
elevated.
• Extend each of the (6) leg poles until
the locking buttons “click,” and lock
the poles into place.
3
(continued on other side)
Stake Tent, Secure Ground
Vents and Guylines
• Drive stakes at a 45º angle
through web loop at base of
tent to secure to ground.
(Detail 5)
• Floor of tent should be taut when staked properly.
([[HJO9HPUϫ`
• 'UDSHUDLQþ\RYHUWHQWSODFLQJ“CORE” logo over door.
• 6QDSSODVWLFFOLSDWWDFKHGWRVWUDSORFDWHGDWFRUQHURIUDLQþ\RQWR
the upper portion of the button box on leg pole labeled RAINFLY.
(Detail 1)
• ,QVHUWDZQLQJSROHLQWRVOHHYHRQXQGHUVLGHRIUDLQþ\DERYHGRRU
(Detail 2)
• Insert metal end of awning pole into hole on plastic grommet located
at each side of door.
(Detail 3)
• TLJKWHQVWUDSVRQUDLQþ\WRVHFXUH
• $WWDFKKRRNDQGORRSWDERQWKHXQGHUVLGHRIWKHUDLQþ\WR
each pole.
(Detail 4)
4
RAINFLY
SLEEVE
2
RAINFLY
1
4
3
PLASTIC
GROMMET
6
5
5
RAINFLY
LOCKING
BUTTON
Stake Tent, Secure Ground Vents and Guylines
(continued)
• /RFDWHJX\OLQHVDWWDFKHGWRWKHUDLQþy.
(Detail 6)
• Stake out each guyline at a 45 degree angle.
• Tighten guylines as needed by adjusting the slider up the cord.
• Stake out ground vents on either side of tent (where air intake
graphics are).
5
Install Room Divider
NOTE:
The divider curtain provides extra privacy in
your tent.
• To install it, attach divider’s plastic toggles to corre-
sponding loops on the wall inside the tent.
(Detail 7)
6
7
CAUTION:
USB is not compatible with charging external device.
IMPORTANT: Remove battery pack before taking down tent. Failure to do so will
drain the batteries and possibly damage the tent fabric.
Lighting Component:
Slide battery pack into
pocket located inside
the tent.
Add 4-D batteries to
empty battery pack.
(Batteries not included)
Zip up pouch, then plug
in battery pack cord
into lighting connector.
CABIN
NIGH T
LIGHT
Press buttons
on switch box
located on
either inside
or outside of
tent to turn on
lighting.
OPTION 1
OPTION 2
For optimized performance, use a Rechargeable Portable Power Pack
with a 5V, 1A output.
Slide Power Pack into
pocket located inside
the tent.
RECHARGEABL
E
PORTABLE POW
ER
(not included)
Rechargeable
Portable Power
Pack
(not included)
Zip up pouch, then plug
lighting connector into
port on Power Pack.
CABIN
NIGH T
LIGHT
Press buttons
on switch box
located on
either inside
or outside of
tent to turn on
lighting.
Lift up on corner joints until eave poles at 3-way side hubs are extended.
NOTE:
2 people will be needed to erect and extend the tent poles.
NOTE:
Pressing the "NIGHT LIGHT" button activates
amber-colored lights to help preserve night vision
Corner Telescoping
Leg Pole
Side Eave Pole
#91241
Mid Eave Pole
Mid Telescoping Leg Pole
#91240
#91241
