Exhaust System
Installation
Axle Back Exhaust System
Dual Rear Exit w/ Twin 4” Pro-Series Tips
BMW F06, F12, F13 M6
PN 14929 & 14929BLK
Please take time to read and understand these installation instructions.
CORSA recommends that the installation of this system be performed by a qualified service center or professional
muffler installer who has the necessary equipment, tools and experienced personnel. However, if you decide to
perform this install, the use of a hoist and an additional person will be required.
CAUTION:
Never work on a hot exhaust system. Allow time for the vehicle to cool. Always wear eye protection when
working under a vehicle.
Recommended Tools:
3/8” drive ratchet
3/8” drive 13mm deep socket
3/8” drive 15mm deep socket
3/8” drive 1/2” deep socket
3/8” drive 3” extension
3/8” drive 6” extension
1/4" drive ratchet
1/4" drive 7mm socket
Safety glasses
T30 torx bit socket or screwdriver
Chain-style pipe cutter
Grommet pullers
Soap and water solution
Permanent Marker
Tape measure
Torque Wrench
Penetrating lubricant spray
Please confirm that all parts are present before beginning the factory exhaust system removal and CORSA exhaust
system installation.
Bill of Materials
1. 13MV2056
– Rear Muffler Assembly – Passenger
2. 13MV2059
– Rear Muffler Assembly – Driver
3. 13MV3007
– Tip Assembly – Driver
4. 13MV3008
– Tip Assembly – Passenger
5. 13MV7055
– Hardware Kit