Mounting Instructions for TH015 Outdoor Clock
–Tools Required—
•Builders Level
•Adjustable Wrench
•Allen Wrench (Provided)
•Drill
Assembly
Estimated assembly time is 30-45 minutes.
Mounting Method 1: Wet Concrete
a.
To ensure adequate support, the concrete footing used to mount this lamp post should be
at least 12" X 12" and 16" deep. Use the anchor bolt template, included inside the box, to
identify accurate mounting locations for each anchor bolt.
b.
Set Anchor Bolts into wet concrete, as shown in
Diagram A
, by gently wiggling the bolts while
pressing downward. Be sure to leave approximately 1" - 1.25" above the cement allowing
enough threads to mount base to ground.
c.
Allow concrete to cure
24-48 hours before assemb-
ling clock on base.
Anchor Bolt
Diagram A
Paper Template
Wet Concrete
