DO
GUIDE
DM-PSU-16 Rear Panel Connections
NOTE
: Ensure that the device is properly grounded by connecting the chassis ground lug to an
earth ground (building steel).
NOTE
: The eight POWER ports of the DM-PSU-8 and the sixteen POWER ports of the
DM-PSU-16 are PoDM and HDBaseT
®
PoE PSE (Power Sourcing Equipment) ports. Any wiring that is
connected to a PoDM or HDBaseT PoE port is for intrabuilding use only and should not be connected
to a line that runs outside of the building in which the PSE is located.
DM-PSU-8/DM-PSU-16
8-Port/16-Port PoDM Power Supply for DM 8G+
®
I/O Cards
DO
Install the Device
The Crestron
®
DM-PSU-8 and DM-PSU-16 can be mounted into a rack or placed onto a flat surface.
Mounting into a Rack
Each device occupies 1U of rack space. Using a #1 or #2 Phillips screwdriver, attach the two
included rack ears to the device. Then, mount the device into the rack using four mounting screws
(not included).
Placing onto a Flat Surface
When placing the device onto a flat surface or stacking it with other equipment, attach the included
feet near the corners on the underside of the device.
DO
Connect the Device
Connect the device as required for the application.
DM-PSU-8 Rear Panel Connections
DO
Check the Box
QTY PRODUCT
COLOR
PART NUM.
2
Bracket, Rack Ear, 1U
2032122
4
Foot, 0.5" x 0.5" x 0.23", Adhesive
Black
2002389
1
Power Cord, 6' 7" (2 m)
4505164
POWER
MAX 15.4 W/PORT 1–8:
To POE IN port of DM 8G
®
I/O card
or to HDBaseT
®
device
100–240 V ~50/60 Hz
2.2–1.0 A:
Mains power input
Ground
POWER
MAX 15.4 W/PORT 1–16:
To POE IN port of DM 8G I/O card
or to HDBaseT device
100–240 V ~50/60 Hz
3.5–1.6 A:
Mains power input
Ground
