The Crestron®
is a DigitalMedia 8G+® wall plate
transmitter that supports 4K60 4:4:4 and HDR (High Dynamic Range)
video. The transmitter provides a cost-effective solution for a single AV
source as part of a complete Crestron DigitalMedia™ system.
In the Box
1
DM-TX-4KZ-100-C-1G DigitalMedia 8G+® Wall Plate
Transmitter
Additional Items
1
Bracket, Surface Mount (2016054)
1
Power Pack, 24 VDC 0.75 A, 100-240 VAC (2045866)
1
Connector, 2-Pin (2003574)
1
Connector, 3-Pin (2003575)
2
Screw, 6-32 x 3/4 in., Truss Head, Combo (2009211)
2
Screw, 6-32 x 1/4 in., Pan Head, SEMS (2007218)
DM-TX-4KZ-100-C-1G-B-T Only
1
Faceplate Assembly, 1 Gang, Textured Black (4523149)
1 Front Faceplate, Plastic (2043449)
1 Rear Faceplate, Plastic (2043453)
2 Screw, 6-32 x 1/4 in., Flat Head, Phillips (2007211)
DM-TX-4KZ-100-C-1G-W-T Only
1
Faceplate Assembly, 1 Gang, Textured White (4522347)
1 Front Faceplate, Plastic (2043379)
1 Rear Faceplate, Plastic (2043380)
2 Screw, 6-32 x 1/4 in., Flat Head, Phillips (2007211)
Install the Transmitter
Mount the transmitter into an electrical box, onto a flat surface, or onto a
rack rail. Connect the rear of the transmitter before mounting it into an
electrical box. If the transmitter is to be mounted onto a flat surface or
rack rail, connect the rear of the unit after it is mounted.
Connecting the Rear of the Transmitter
The DM OUT port on the rear of the transmitter is a PoDM (Power over
DM) and HDBaseT® PoE powered device (PD) port. To receive PoDM, the
port requires connection to a DigitalMedia switcher or other DigitalMedia
equipment that has a PoDM power sourcing equipment (PSE) port. To
receive HDBaseT PoE, the port requires connection to equipment that has
an HDBaseT PoE PSE port. Wiring that connects to a PoDM or HDBaseT
PoE port is for intrabuilding use only.
Connection of the transmitter to the included power pack is not required
when PoDM or HDBaseT PoE is used to power the transmitter.
Connections to Rear of Transmitter
DM-TX-4KZ-100-C-1G
Quick Start
1
