CS-2004 WDC
Remote Control Alarm System with CoolGlow & SecurWatch®
INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION:
CONGRATULATIONS
on your choice of a Remote Alarm System by Crimestopper Security Products Inc.
This system features both a
4-Button CoolGlow Transmitter
and a
SecurWatch® Sports Watch
Transmitter
that feature anti code-grabbing technology. The remote code changes with every use of the
transmitter making it impossible to scan or record the codes for use later on. This booklet contains the
information necessary for installing, using, and maintaining the many features of this alarm system. If any
questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support
number below.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Siren,
L.E.D., Power, Ground, Doorpin, etc.
-OPTIONAL:
These are features to be connected only if desired or agreed upon by the installing dealer (i.e.
Door Locks, Flashing Lights, Starter Kill, Hood, Trunk, and Auxiliary Remote Outputs etc.)
*NOTE:
If the system is programmed for Carjack Protection, AUX 1 will not be available when using the
SecurWatch® Remote Transmitter
.
AUX 1 can still be operated with the 4-Button CoolGlow transmitter
when the system is setup for Carjack.
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.
Summary of Contents for CS-2004 WDC
Page 17: ......
