CS-2100
REMOTE CONTROL ALARM SYSTEM
INSTALLATION & OPERATING INSTRUCTIONS
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY:
These are features that must be connected in order for the system to operate properly i.e. Siren, L.E.D.,
Power, Ground, Doorpin, etc.
-OPTIONAL:
These are features to be connected only if desired or agreed upon by the installing dealer (i.e. Door
Locks, Starter Kill, Hood, Trunk, and Auxiliary Remote Output etc.) Optional features may require extra parts and/or
labor to install.
TECH SUPPORT
Mon-Fri 8:00 AM -4:30 PM Pacific Time
(800) 998-6880
www.crimestopper.com
email@crimestopper.com
INSTALLATION CAUTIONS & WARNINGS
BEFORE BEGINNING
, check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS,
ABS BRAKES, AND BATTERY).
TO PREVENT A POSSIBLE DEAD BATTERY
remove vehicle dome light fuse while working on the vehicle. MAKE
CERTAIN TO REINSTALL FUSE PRIOR TO TESTING FOR DOOR TRIGGERS.
DO NOT EXCEED MAXIMUM OUTPUT RATINGS! - SERIOUS DAMAGE MAY OCCUR. LIMITS FOR ALARM
FUNCTIONS ARE LISTED WHERE APPLICABLE. IF UNSURE ABOUT CURRENT LOAD, MEASURE LOAD WITH
AN AMP-METER.
REMOVE MAIN SYSTEM FUSE(S)
before jump starting the vehicle or charging the battery at high boost.
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions: 1) This device may not cause interference, and (2) this device
must accept any interference that may be received, including interference that may
cause undesired operation. The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modification to this equipment. Such
modification could void the user's authority to operate the equipment.
Summary of Contents for CS-2100
Page 7: ...POWER DOOR LOCK WIRING ...
Page 9: ......
