PART NO. 769-05636 P00
(07/10)
NEED HELP?
CALL 1-877-282-8684 IN U.S. OR 1–800–668–1238 IN CANADA
HB227
2-Cycle
Gasoline Blower
IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.
Removing Unit From Carton
Assemble The Unit
Insert bump on blower
tube into slot on blower
outlet.
Twist blower tube clockwise
until bump locks into place.
Assemble The Unit
Twist nozzle clockwise until
tight.
Mix thoroughly in separate
fuel can:
– 3.2 fl. oz. of 2-cycle
engine oil
– 1 gallon of unleaded
gasoline
NOTE:
Do not mix directly in
fuel tank.
Place unit on a level surface.
Fill fuel tank.
Press
primer bulb
10 times
,
or until fuel is visible
Move
choke lever to
Position 1
.
SQUEEZE
and
HOLD
throttle for
ALL
further
steps.
Crouch in starting position.
Pull
rope
5 times
.
Move
choke lever to
Position 2
and squeeze
throttle.
1
1
2
Remove all contents from
carton.
5
6
7
1
8
9
3
Pull
rope
3-5 times
to start
engine.
Run
unit for
30-60
seconds
to warm up.
Starting The Unit
10
11
12
13
14
Primer
Bulb
10 X
5 X
3-5 X
Need Help?
Call 1-877-282-8684
DIDN’T START?
Repeat these instructions.
IF
engine fails to start after 2 attempts,
move choke lever to position 3 and pull
the starter rope until engine starts
IF
unit still fails to start, refer to the
operator’s manual for additional starting
and troubleshooting information
Insert bump on other end of
blower tube into slot on
nozzle.
4
1 Gallon
3.2 oz
40:1
Choke
Lever
Continue to squeeze
throttle.
Move
choke lever
to
Position 3
.
Continue to squeeze
throttle.
Run
unit for an
additional 60 seconds
to
complete warm-up. Unit
may be used during this
time.
1
15
16
Starter Rope
On/Off Stop Control
Nozzle
Trigger
Handle
Cruise Control
Starting The Unit
Blower Tube
Outlet
Tube
Slot
Bump
Outlet
Tube
Tube
Nozzle
Bump
Slot
Tube
Nozzle
Fuel Cap
Primer Bulb
Choke Lever
Choke
Lever
Choke
Lever
No Tools Required!
Español — Page 9
English — Page 1
Français — Page 5
Operator’s Manual
