Series II
ODYR-17-1/SLX-17-1 CLOCK WITH COMPASS AND TEMP
Introduction:
The Odyssey Series II gauges from Dakota Digital, Inc. incorporates the reliability and quality of our
standard gauges, along with several unique features and easy mounting. These features include:
•
Industry standard 2-1/16” gauge size.
•
Weather-proof
construction.
•
12 hour format with AM/PM display.
•
8 point compass heading. (N, NW, W, SW, S, SE, E, NE)
•
Outside Temperature display.
•
Microprocessor stabilized readings.
•
Night dimming with lens label lighting.
•
Non-Glare, high contrast lens.
•
High Visibility VFD display for sunlight readability.
Operation:
The white/red wire should be connected to a constant 12 volt feed to keep the time. The red wire should
be connected to a 12 volt accessory feed. The case provides the gauge ground. Connect the ring terminal from
the black wire to a screw at the top rear of the case. Attach the loose end of the black wire to a main vehicle
ground and also the temp sensor black wire. When the blue wire has 12 volts, it will dim the display for night
viewing. The gray wire attaches to the temp sensor red wire. The 3-pin plug will mate into a connector from the
compass sensor.
The push button on the front of the display switches between the three different display screens and is
also used for calibration. The three display screens are clock, compass, and temp all displayed at the same time;
clock only in tall format; compass and temp only in tall format. Pressing and releasing the switch while the
ignition key is on will switch between the different screens.
WIRING COLOR CODE FOR GAUGE:
RED
+12 volt power with key on
WHITE/RED
+12 volt constant power
BLACK
ground for gauge and case and temp sensor black wire
(the ring terminal should attach to the top screw on the case.)
BLUE
night
dimming
GRAY
to temp sensor red wire.
3-PIN plug
to compass sensor
WIRING COLOR CODE FOR TEMP SENSOR:
RED
to display gray wire
BLACK
to ground (display black wire)
