background image

Introduction

The Hot Stone Deluxe pedal power supply was specifically designed to meet the higher power 

requirements of modern digital effect pedals while providing sufficient outputs to power any 
battery operated pedal. All outputs are completely isolated, filtered and regulated to provide 

clean, ripple free DC voltage. Isolation and short circuit protection on each output ensures that 
there will be no hum, noise, or pedal interaction. 

The Hot Stone Deluxe provides:

 Eight isolated outputs with a total, ripple-free current of 1600mA.

 Two high current, 400mA, 9 and/or 12V outputs capable of powering Eventide™ Factor, 

Strymon™, Boss™ Twin, TC™ Nova, Line6™ modelers.

 Two medium current, 9 or 12V outputs capable of 200mA each.

 Two variable voltage outputs for simulating used carbon batteries.

 Custom magnetically shielded toroidal transformer

 Short circuit protection on all outlets

Box Contents

Hot Stone Deluxe

AC power cord

(8) DC cables with 5.5x2.1mm black barrel connectors

(2) DC cables with 5.5x2.5mm blue barrel connector

(1) DC cable with 3.5mm mini plug

Manual and Warranty

Declaration of Conformity

Decibel Eleven declares that this product complies with the European Union Council Directives and Standards 
requirements for the Low Voltage Directive (2006/95/EC) and the EMC Directive (2004/108/EC).

The European Union’s (EU) WEEE (Waste Electrical and Electronic Equipment) directive is for waste management of 

electronic equipment sold into EU countries.The symbol on our product (shown) indicates that this product must not 
be disposed of with other waste. It is the user’s responsibility to dispose of their waste electrical and electronic 

equipment by handing it over to an approved reprocessor or recycler. For more information on proper recycling, 
please contact your local city office or Decibel Eleven distributor.

DECIBEL11.COM

DB-11 HOT STONE OPERATING TEMPERATURE

The Hot Stone is a linear power supply designed for low noise and high 
output current. Higher currents require higher heat dissipation. The Hot 

Stone is designed to radiate heat. This is normal to its operation. However, 
care should be taken to keep the top cover clear and freely exposed to air.

Summary of Contents for Hot Stone Deluxe

Page 1: ...es with 5 5x2 5mm blue barrel connector 1 DC cable with 3 5mm mini plug Manual and Warranty Declaration of Conformity Decibel Eleven declares that this product complies with the European Union Council Directives and Standards requirements for the Low Voltage Directive 2006 95 EC and the EMC Directive 2004 108 EC The European Union s EU WEEE Waste Electrical and Electronic Equipment directive is fo...

Page 2: ... type fuse Should your Hot Stone Deluxe stop working where there is no power being supplied to your pedals and the green power indicator on the Hot Stone front panel is not lit it is recommended to check the condition of the fuse To access the fuse first be absolutely certain that the unit is detached from its AC power cable Then remove the 2 flat head screws along the bases of the front and rear ...

Page 3: ...se down to about 5V fully counter clockwise This can be used to simulate a used carbon battery giving transistor fuzz pedals a unique brown sound The effect is not typically useful on effects which utilize opamps in the circuitry The voltage control is not intended to be a calibrated control The typical response when rotating the knob counter clockwise will begin as a very gradual voltage drop inc...

Page 4: ...r 2 at 12V using the BLUE 5 5x2 5mm cable It is also possible to power them using a current doubling cable from outputs 5 and 6 set to 12V Strymon pedals can be powered from output 1 or 2 at 9V using the standard BLACK cable Other pedals will list power requirements in their manual or on the pedal itself Some manufacturers list actual power requirements while others may list only the rating of the...

Reviews: