PARTS LIST:
ITEM
QTY
NUTSERT TOOL
1
SHOCK
1
CABLE/BALL MOUNT
1
WASHER
1
BALL MOUNT
1
NUTSERT
1
TORX WRENCH
1
CABLE CLIP
1
THREAD LOCK TUBE
1
TOOLS REQUIRED:
T-45 TORX
M5 ALLEN WRENCH
PLIERS
10MM WRENCH
13MM WRENCH
17MM WRENCH
TAPE MEASURE
This product can only be
STEP 2)
STEP 3)
installed on the driver's side
Using a M5 Allen wrench and
Mark one side of the nut and
Apply thread lock to the
DZ 43300
TAILGATE ASSIST
DODGE RAM 2002-2011
installed on the driver's side
Using a M5 Allen wrench and
Mark one side of the nut and
Apply thread lock to the
of the vehicle.
a 10mm wrench, install the
count the number of revolutions
threads of the ball mount.
nutsert in the opening by the
to insure the correct number
Install the ball mount into the
STEP 1)
tailgate pivot point.
of full turns.
nutsert using a 13mm
Adjust the nutsert tool so
Overtightening the nutsert
wrench/socket.
there is 3/4" from the washer
can strip the threads and cause
to the head of the bolt.
the nutsert to be unusable.
Remove the nutsert tool
when installation is complete.
The nutsert should be
tightened between 9 and 12
360 degree turns.
