Installing the LSI 9285 PCIe Card on
Dell PowerEdge C6220 Systems
Follow the procedure in this document to install the LSI 9285 PCIe card on your
Dell PowerEdge C6220 1U node.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your product
documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty.
Read and follow the safety instructions that came with the product.
The following items are available in the PCIe card kit:
•
LSI 9285 PCIe card
•
rubber jumper
To install the LSI 9285 PCIe card:
1
Turn off the system, including any attached peripherals, and disconnect the
system from the electrical outlet.
2
Open the system.
3
Locate the jumper PCN3 on the system board.
4
Ensure that you place the rubber jumper on pin 2 of the system-board jumper.
For more information see Figure 1.
