BT Headphone Manual
Congratulations with your new Bluetooth headset. Please read this manual before using it to make sure you
use it correct.
Headset overview
English
English
Next Song/
Next Song/
On & Off/Play & Pause
On & Off/Play & Pause
Previous Song/Volume-
Previous Song/Volume-
Indicator
Indicator
Mic
Mic
Line-in
Line-in
Micro USB charging port
Micro USB charging port
Pairing
1.
Ensure that your phone or Bluetooth device is switched on.
2.
To pair the headset that has not been previously paired with a device, please switch on the headset by
push and hold power button for approximately 5 seconds., the headset starts in Bluetooth search mode
(red/blue light flashes quickly and alternately and there is a prompt tone). Press and hold the power key
for 3 seconds, it will go into reconnection mode.
3.
Activate Bluetooth on your phone or Bluetooth device, and set it to search for Bluetooth device.
4.
Select “DENVER BTH-205” from the list of found devices on your phone or Bluetooth devices.
5.
When Bluetooth is paired successfully, there will be prompt tone and the blue light turns to lighting
continuously.
Switch On
After unit has been paired (look above), just hold power until the LED lights up and then let go. When it has
been paired it will automatically reconnect once turned on.
Switch Off
To switch off, press and hold the Power key about 3 seconds. There is a prompt tone and a red indicating
light. If the headset is not connected to a device within 10 minutes, it switches off automatically.
