background image

8514-

141-001

The dryer must not be stored or installed where it will be exposed to water and/or weather.

OPERATOR’S MANUAL

for

DDAD50KC 

Series Dryers

c

manufactured 

by

Dexter Laundry Inc.

2211 W. Grimes

Fairfield, Iowa 52556

WARNING: For your safety the infor-
mation in this manual must be fol-
lowed to minimize the risk of fire or
explosion or to prevent property dam-
age, personal injury or loss of life.

Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.

– WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electrical  switch; do

not use any phone in your building.

Clear the room, building or area of all
occupants.

Immediately call your gas supplier from
a neighbor’s phone.  Follow the gas
supplier’s  instructions.

If you cannot reach your gas supplier,
call the fire department.

– Installation and  service must be performed by

a qualified installer, service agency or the
gas supplier.

You, the purchaser, must post in a prominent loca-
tion instructions to be followed in the event the user
smells gas.  Consult your local gas supplier for
procedure to be followed if the odor of gas is
present.

Post the following “For Your Safety” caution in a
prominent location:

FOR YOUR SAFETY

Do not store or use gasoline or other flammable
vapors or liquids in the vicinity of this or any other
appliance.

It is important that you read this Manual and retain it for
future reference.  For service or replacement parts,
contact the distributor in your area or the manufacturer.

AVERTISSEMENT.  Assurez-vouz de
bien suivre les instructions données
dans cette notice pour réduire au
minimum le risque d'incendie ou
d'explosion ou pour éviter tout
dommage matérial, toute blessure
ou la mort.

Ne pas entreposer ni utiliser d'essence ni d'autres
vapeurs ou liquides inflammables dans le voisinage
de cet appareil ou de tout autre appareil.

– QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE

GAZ:

Ne pas tenter d'allumer d'appareil.

Ne touchez à aucun interrupteur.  Ne pas
vous servir des téléphones se trouvant
dans le bâtiment où vous vous trouvez.

Évacuez la pièce, le bâtiment ou la zone.

Appelez immédiatement votre
fournisseour de gaz depuis un voisin.
Suivez les instructions du fournisseur.

Si vous ne pouvez rejoindre le fournisseur
de gaz, appelez le service des incendies.

– L'installation et l'entretien doivent être assurés par
un installateur ou un service d'entretien qualifié ou
par le fournisseur de gaz.

POUR VOTRE SÉCURITÉ

Ne pas enteposer ni utiliser d'essence ni d'autres
vapeurs ou liquides inflammables dans le voisinage
de cet appareil ou de tout autre appareil.

Summary of Contents for DDAD50KC Series















Reviews: