background image

 

B2372TIR 

About manual

       

  INSTRUCTION MANUAL

Do not open or modify

Do not open the case except during maintenance and 
installation, as it may be dangerous and cause damages.

Do not put objects inside the unit

Make sure that no metal objects or flammable substances 
get inside the camera. It could cause fire, short-circuits or 
damages.

Be careful when handling the unit

To prevent damage, do not drop the camera or subject it to 
strong shock or vibration.

Install away from electric or magnetic fields

Protect from humidity and dust

Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen 
or boiler room, as the temperature may rise to high levels.

Cleaning

Dirt can be removed from the case only by wiping it with 
a soft cloth moistened with a soft detergent solution.

Mounting Surface

The mounting surface material must be strong enough to 
support the camera.

Before installing and using the camera, please read this 
manual carefully. 
Be sure to keep it handy for future reference.

DIMENSION (mm)

5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support: 1-866-446-3595 / 813-888-9555

WARRANTY INFORMATION 

PRECAUTIONS 

Digital Watchdog

(referred to as “the Warrantor”) warrants 

the Camera Series against defects in materials or 
workmanship as follows:

LIMITS AND EXCLUSIONS

There are no express warranties except as listed above. 
The Warrantor will not be liable for incidental or 
consequential damages (including without limitation

Before sending the camera out for repair, check the 
items below. If the problem persists  after checking 
these items, contact your service center.

If no image appears.

Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been 
adjusted correctly (with the level volume) ?
Is there adequate illumination?

If the image is unclear

Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely 
affect the images.

Gently wipe any dirt or fingerprints off the lens

with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?

TROUBLESHOOTING

Do not open or modify

Do not open the case except during maintenance and 
installation, as it may be dangerous and cause damages.

Do not put objects inside the unit

Make sure that no metal objects or flammable substances 
get inside the camera. It could cause fire, short-circuits or 
damages.

Be careful when handling the unit

To prevent damage, do not drop the camera or subject it to 
strong shock or vibration.

Install away from electric or magnetic fields

Protect from humidity and dust

Protect from high temperature

Be careful when installing close to the ceiling , in a kitchen 
or boiler room, as the temperature may rise to high levels.

Cleaning

Dirt can be removed from the case only by wiping it with 
a soft cloth moistened with a soft detergent solution.

Mounting Surface

The mounting surface material must be strong enough to 
support the camera.

Before installing and using the camera, please read this 
manual carefully. 
Be sure to keep it handy for future reference.

DIMENSION (mm)

5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support: 1-866-446-3595 / 813-888-9555

WARRANTY INFORMATION 

PRECAUTIONS 

Digital Watchdog

(referred to as “the Warrantor”) warrants 

the Camera Series against defects in materials or 
workmanship as follows:

LABOR

: For the initial five (5) years from the date of original 

purchase, if the camera is determined to be defective, the 
Warrantor will repair or replace the unit, with 
new or refurbished product at its option, at no charge. 

PARTS

: In addition, the Warrantor will supply replacement 

parts for the initial five (5) years.  To obtain warranty or out 
of warranty service, please contact a Technical Support 
Representative at 

1-866-446-3595

Monday through Friday 

from 9:00 AM to 5:00 PM Eastern. 
A purchase receipt or other proof of the date of the original 
purchase is required before warranty service is rendered.  
This warranty only covers failures due to defects in 
materials and workmanship which arise during normal use. 
This warranty does not cover damage which occurs in 
shipment or failures which are caused by products not 
supplied by the Warrantor or failures which result from 
accident, misuse, abuse, neglect, mishandling, 
misapplication, alteration, modification, faulty installation, 
set-up adjustments, improper antenna, inadequate signal 
pickup, maladjustment  of consumer controls, improper 
operation, power line surge, improper voltage supply, 
lightning damage, rental use of the product or service by 
anyone other than an authorized repair facility or damage 
that is attributable to acts of God. 

LIMITS AND EXCLUSIONS

There are no express warranties except as listed above. 
The Warrantor will not be liable for incidental or 
consequential damages  (including, without limitation, 
damage to recording media) resulting from the use of 
these products, or arising out of any breach of the 
warranty. All express and implied warranties, including 
the warranties of merchantability and fitness for 
particular purpose, are limited to the applicable warranty 
period set forth above.
Some states do not allow the exclusion or limitation of 
incidental or consequential damages, or limitations on 
how long an implied warranty lasts, so the above 
exclusions or limitations may not apply to you. 
This warranty gives you specific legal rights and you 
may also have other rights that vary from state to state.
If the problem is not handled to your satisfaction, then 
write to the Address above.

Service calls which do not involve defective materials or 
workmanship as determined by the Warrantor, in its 
sole discretion, are not covered. Costs of such service 
calls are the responsibility of the purchaser.

Before sending the camera out for repair, check the 
items below. If the problem persists  after checking 
these items, contact your service center.

If no image appears.

Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been 
adjusted correctly (with the level volume) ?
Is there adequate illumination?

If the image is unclear

Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely 
affect the images.

Gently wipe any dirt or fingerprints off the lens

with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?

WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC 
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO 
RAIN OR MOISTURE.

TROUBLESHOOTING

Reviews: