2TCASE - Display Case
*** 2 People are needed for assembly***
Step 1: Remove all pieces from black
travel case
***Bottom Case Assembly***
Step 2: Needed: Front & back panels with
black feet.
Have (1) person hold the panels on
edge parallel to each other (as shown)
Step 3: Needed: (2) Side panels with extended
corner extrusion (not the side panels
with the washer & screw)
Have 2nd person slide the panels in
(as shown)
Step 4: Use the included allen key to tighten the
(4) screws inside the legs of the side panels
Step 5: Using (2) people, stand the bottom
case assembly upright & set aside
Step 6: Needed: Wooden floor panel
With the unit upright, open the door &
insert the wooden floor panel by pushing
it down in the base until it is fully seated in
the extrusion. The wooden floor panel is
pressure-fitted into the unit, so extra force
may be required to properly place panel in
the unit
Note: The wooden floor panel is the panel with all the
hardware attached on the underside. Remove all
hardware from the panel before assembly
Step 7: Assemble the bottom by putting together
the (3) non-door panels - then slide in the
light panel and slide on the door
***Top Case Assembly***
Step 8: Using (2) people, stand the top case
assembly upright
Very Important: The top case assembly must be picked up
by the front & back panels. The side panels of the top
case assembly are not secured & will slide out of the
unit if not picked up properly. Highly recommended to
see our assembly video online under the SKU:
2TCASESLVS & 2TCASESBLKL
Page 1
