DivKid ‘Mutes’ DIY Build Guide
Hello and thanks a lot for choosing Mutes semi DIY kit!
This manual will guide you through the build of the Mutes module. First of all,
please take your time to inspect all parts involved and get familiar with
what’s ahead of you.
Some steps are not obvious, so even if you're an experienced DIYer please
read the steps thoroughly before starting.
The fact that SMD components
are pre-soldered does not mean this is an easy one
. Please be careful
and doublecheck all your steps.
In this semi kit you get two boards with SMD pre-assembled, front panel and
the rest of the mechanical components needed to finish a Mutes modules.
Once again thanks a lot for choosing Mutes!!
GOOD LUCK!
_______________________________________________________________________________________
MAIN PCB
We will start assembling the Main PCB (smallest one) This board has main circuit components
pre-soldered and we will just solder Vactrols, power conector and Female connectors.
Vactrols ‘VTL5C1’ (4)
Description / Notes
Mind polarity when placing the Vactrol. Short leg for LED negative in
silkscreen.
Solder points
LDR1, LDR2, LDR3, LDR4
Summary of Contents for Mutes
Page 6: ......
